Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
The cabinet is made of hardened plastic. The enclosure consists of a mounting rail with two throats, fitted with gaskets, and a motor which is connected to the throats by quick-release clips. The design allows the motor section to be removed without the need to disconnect the pipe.
Running wheel
The impeller is made of plastic.
Motor
The AC motors in the TD-EVO 125 to TD-EVO 315 fans have triple windings, allowing triple speed operation. The TD-EVO VAR fans have an integrated triac controller allowing continuous power change according to the potentiometer setting in the fan terminal block or the 0-10 V analog input. The motors are equipped with thermal protection. The bearings are ball bearings with grease packing for life. Insulation class F, protection class IP44. Supply voltage 230 V, 50/60 Hz.
Screwdriver
The terminal box is located on the fan housing.
Speed control
For TD-EVO triple winding AC motors, the speed is switched in three stages using COM 3 or INTER 4P controllers, or voltage change control can be used with REB (stepless control) or REV (five stage control) controllers. On the TD-EVO VAR, the speed is continuously regulated by an integrated triac controller with 0-10 V analog input. The TD-EVO T with triple winding only switches the speed. The switching time can be set to 1-30 min.
Options
- TD-EVO basic version, three-turn
- TD-EVO T version with adjustable switching time 1 to 30 minutes, three-turn
- TD-EVO VAR single-turn version with integrated triac controller and adjustable switching time 1 to 30 minutes
Mounting
Fan mounting is possible in any fan position. The enclosure must not transmit mechanical stresses from the ductwork. A flexible connection to the ductwork is recommended.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
