Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
The cabinet is made of high quality tough plastic (TD-350 to TD-1000) or epoxy coated galvanized steel sheet (TD-1300, TD-2000). Sizes TD-350 to TD-1000 include a patented vector noise absorber, sizes TD-1300 and TD-2000 have fiberglass noise insulation. The design allows for easy removal of the motor section.
Motor
EC motor with thermal and electronic overload protection. Ball bearings. Insulation class B, IP44 protection. Operating temperature -20 °C to +40 °C.
Clamps
The terminal block is located on the fan housing, it is rotatable 360° for cable connection from any direction (only for TD-350 to TD-1000). For sizes TD-1300 and TD-2000 the terminal block is removable, protection IP55.
Speed control
Motors are regulated by a potentiometer located in the terminal block or by an external REB-Ecowatt speed controller. The speed can also be controlled linearly by a 0-10 VDC signal from a temperature, humidity or CO2 sensor.
Mounting
Mounting is possible in any fan position. The enclosure must not transmit mechanical stresses from the ductwork. A flexible connection to the ductwork must be used.
Instructions
Due to their very low profile, high efficiency and low noise, the fans are suitable for demanding applications where their very economical operation is also applicable. They are also suitable for DCV (demand controlled ventilation) applications.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
