Share on Facebook
Tweet
Send emailCabinet
The cabinet is made of ABS, colour white RAL 9016. ECO-A has a rearward outlet for a pipe diameter of 78 mm. ECO-U has a rearward (Z) or upward (H) outlet for a pipe diameter of 75-80 mm. ECO-A F90 has a rearward outlet for a diameter of 100 mm. There is a check valve on the discharge. Installation is on the wall, flush or in the ceiling. The front grille includes a filter and silencer.
Running wheel
The impeller is radial with forward curved blades, press-fitted to the outer rotor.
Motor
The motor is asynchronous with external rotor, high efficiency and low power consumption. The motor has ball bearings and is equipped with thermal overload protection, max. ambient temperature is 40 ˚C. IPX5 protection.
Square box
The terminal box is accessible by removing the front grille in the fan housing.
Speed control
Speed control is performed by electronic controllers. Two-speed fans ECO-U GL, ECO-A GL are also available.
Variants
- Z - rear outlet (only U-plastered version)
- H - top outlet (only U-plastered version)
- GL- two-speed version
- F90 - fireproof version
Mounting
The ECO-U is installed flush or in the ceiling, in horizontal and vertical position. The extension for extraction of ancillary spaces can be positioned on three sides of the enclosure as required, see illustration. The fan is supplied assembled, the cabinet is covered with a temporary anti-fouling lid and is replaced with a loose-fitting faceplate after installation. The cabinet, motor, fan and faceplate can be supplied separately on special order. The inaccuracy of the brickwork can be compensated by rotating the faceplate by up to approx. 10˚. ECO-A is mounted on the wall or on the ceiling.
Accessories
The U version does not include an extension for extraction of adjacent spaces, to be ordered separately.
Instructions
The fans are suitable for very demanding interiors, architectural designs and for extracting odours directly from sanitary ware.
By following the instructions in the manual, no risk should arise regarding safety, health and the environment in accordance with the EC Directives (with CE marking). The same applies to other products used in the equipment or during installation. Please consider the following general information important:
- observe the safety instructions to avoid damage to the equipment or personal injury
- the technical information given in these instructions must not be altered
- it is forbidden to interfere with the equipment's motor
- in order to comply with the EC directives, the equipment must be connected to the mains in accordance with the applicable regulations
- the equipment must be installed in such a way that, the equipment must comply with the applicable regulations for the operation of electrical equipment
- it must always be disconnected from the power supply before any tampering with the equipment
- appropriate tools must be used when handling or maintaining the equipment
- the equipment must be used only for the following purposes, for which it is intended
- this appliance must not be used by children under the age of 8 years and by persons with reduced physical, sensory or mental abilities, or persons with a lack of experience and knowledge, unless they are supervised by a responsible person or have been adequately instructed in the safe use of the appliance and can understand the risks involved
- the user must ensure that children do not play with the appliance
- cleaning and maintenance of the appliance must not be carried out by unsupervised children
