Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
is made of galvanized steel sheet. The cabinet is equipped with a safety grille on the intake side and a louvre flap on the discharge side. The louvre opens automatically when the fan is started. In case the fan is within reach of people, a safety grille can be installed over the louvre (see accessories).
Running wheel
is made of Al alloy (size 800 steel plate). The impeller is statically and dynamically balanced. The impeller blade angle is set by the manufacturer. The impeller is
driven by a belt (size 800 straight), the housing contains a mechanism for tensioning it.
Motor
is asynchronous with a short armature. Four-pole design. The motor is IP55 rated. Insulation class F. Operating temperature 0 to +40 °C. The winding is equipped with thermal protection. Motor efficiency class IE3.
Square box
is located on the motor.
Speed control
motor speed control is not possible.
Flow direction
is from the grille to the louver.
Noise
is listed in the table of main technical parameters. Measurements are taken at a distance equal to three times the free-field diameter of the impeller.
Mounting
Fans are in principle with the motor axis horizontal. The casing must not transmit mechanical stresses from the building structures. The fan can be built into the walls of buildings. A discharge louver is not sufficient protection against shock from rotating parts. If the bottom edge of the fan is less than 2.5 m above the ground or the fan can otherwise be reached, an additional protective grille must be installed over the louvre. In applications where light penetration into the building must be prevented (e.g. poultry houses), a special blackout cassette can be ordered.
Options
- HIB-P fan with 230 V single-phase motor and discharge louvre
- HIT-P fan with 230/400 V three-phase motor and discharge louvre
Accessories
- SG Kit protective grille on louver
- BO Kit blackout cassette
- HIB/HIT Kit wall mounting frame
Instructions
The fans are designed to supply large volumes of air at low pressure, they are suitable for ventilation of large warehouses, greenhouses, sports and agricultural buildings.
Highlights
Alternatively, motors are supplied with a thermal fuse in the winding. In this case, the wiring diagram supplied with the fan in the documentation must be used. The thermal fuse must always be plugged in, otherwise the motor is not eligible for warranty repair.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
