Share on Facebook
Tweet
Send emailCabinet
The cabinet is made of galvanized steel sheet and is provided with thermal insulation. The impeller is separated from the motor by an insulated bulkhead. A thermostat control is located on the fan shroud. The thermal sensor is located on the fan discharge and has a range of 0-90 °C.
Running wheel
The impeller is radial with forward curved blades, made of galvanized sheet metal. The impeller is statically and dynamically balanced.
Motor
The motor is single phase, 230 V / 50 Hz, with built-in thermal protection and is designed for continuous operation at temperatures up to 180 ºC.
Electric connection
Electrical connection via a lead-out cable under or on plaster. Termination of the fixed supply in the installation terminal block located on the fan cabinet.
Speed control
The fan automatically starts according to the temperature set on the thermostat. It switches off if the temperature of the air flowing from the fireplace insert falls below the set point. The recommended temperature is 40 °C. In addition, the speed can be continuously controlled by the REB controller, but the temperature increase must be taken into account due to the slower air flow.
Noise
Noise emitted by the fan is measured at the inlet, discharge and free field at 3 points on the power curve.
Mounting
Mount the fan in each position of the motor axis. It is primarily mounted in the canopy and at a distance of approximately 2 m relative to the axis of the intake duct. It must be placed on a solid base, for example 2 solid boards, with approximately 5 cm thick non-combustible semi-rigid insulation sandwiched between them. The CHEMINAIR must not be covered with an insulating layer to allow natural ventilation of the engine.
Accessories
- fireplace grilles
Instructions
Fans are suitable for distributing warm air from the fireplace insert to other rooms in the apartment or house.
Caution
All components must be kept at the prescribed operating temperature to avoid damage to them or endangering building structures. Consult the designer or installer for use.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
