Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
is made of black impact-resistant plastic, the base is made of galvanized steel sheet coated with black epoxy paint.
Running wheel
is radial with backward curved blades and is statically and dynamically balanced.
Motor
EC motor with external rotor and thermal overload protection. Grease-filled ball bearings for life. IP44 protection, operating temperature -20 to +60 ºC (190/060) or -20 to +50 ºC (225/088, 250/084).
Square box
It is made of fire-resistant plastic and is placed loosely on the supply cable from the motor. The terminal box contains an ON/OFF control switch. IP65 protection.
Speed control
is carried out by means of a potentiometer located in the terminal block or by an external REB Ecowatt controller. Alternatively, control is via a 0-10 V control signal from a temperature, humidity or CO2 sensor.
Mounting
The TPSB Ecowatt roof ventilators are mounted with a mounting base on horizontal roof structures or prefabricated masonry plinths. JMS and JBS plinths can also be used.
Instructions
TPSB Ecowatt roof fans are powerful and have a very low profile due to their special patented design, allowing them to be used in a wide range of air handling applications.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
