Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
is designed for horizontal (TNHB, TNHT) or vertical (TNVB, TNVT) air exhaust. The fan base is made of galvanized steel sheet, the frame and motor brackets are also electroplated. The fan design optimizes airflow, which increases efficiency and reduces noise. The motor is connected directly to the fan shaft. The fan blade, beams, control cover and deflectors for vertical air outlet are painted RAL 7024 (grey) with very good weather and UV resistance.
Running wheel
The fan is radial with backward curved blades, made of galvanized steel sheet. It is statically and dynamically balanced.
Motor
It is DC, special EC, with external rotor for 1f 230 V/50 Hz (TNHB/TNVB 355-450) or 3f 400 V/50 Hz (TNHT/TNVT 500-710) power supply. The motors are equipped with a thermal fuse as standard. Motor insulation is Class F. Bearings are grease filled for life. Continuous operating temperature -20 to +120 °C, in OTK mode F400 (120).
Screwdriver
with a revision switch is located on the fan housing.
Mounting
The fan is mounted horizontally with the accessories (with the motor axis vertically).
Speed control
is carried out using a potentiometer located in the terminal block or a remote CVF or REB Ecowatt potentiometer. In addition, a signal from external devices (CO2, temperature and relative humidity sensors) or an external pressure sensor with a transducer and 0-10 V or 4-20 mA output can be connected.
Rotation direction
is only possible in one direction, as indicated by the arrow on the fan housing. The opposite direction of rotation may cause motor overload, and the fan will also experience increased noise.
Description
Fans are suitable for extracting smoke and hot air in case of fire, exhausting polluted air from commercial and industrial premises and professional kitchens. Air temperature up to 120 °C.
Options
- TNHx, TNVx Ecowatt VAV
- TNHx, TNVx Ecowatt VAV with display
- TNHx, TNVx Ecowatt COP
- TNHx, TNVx Ecowatt COP with display
- TNHx, TNVx Ecowatt CAV with display
Air Handling Accessories
- JMS-TNxx mounting frame
- JBS-TNxx mounting pedestal
- JKR-TNxx tilt frame
- JCA-TNxx check damper
- JPA-TNxx flange connection adapter
- JAA-TNxx plinth with damper
- JDS-TNxx double inlet extension
EL Accessories
- REV speed controllers
- REB Ecowatt speed controller
- CVF Ecowatt speed controller
- CONTROL Ecowatt Basic speed controller for Ecowatt fans
- AIRSENS air quality sensors
- MSE, MSD motor protection
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
