Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
It is made of steel sheet, coated with black lacquer, the screws are electroplated. The fan in the basic version does not have a protective grille, it can be ordered, see accessories.
Running wheel
is made of Al alloy. The impeller is statically and dynamically balanced. The rotation of the blades is set by the manufacturer.
Motor
is asynchronous with resistive armature, stator with cooling fins, lacquer finish. Motors are 3-phase for 230/400 V or 3-phase for 400 V. The motors are with F class insulation and operating temperature -20 to +40 ˚C. Ball bearings with grease packing for life. IP55 protection. Four-pole motors are equipped with PTC-type thermistors for motor protection.
Speed control
is only possible with a frequency converter.
Rotation direction
can be changed. With a standard impeller, the flow rate drops by approx. 30% in the opposite direction of rotation. The air flow is standard from the motor to the impeller.
Clamps
is plastic as standard. The terminal block is located on the front or side of the engine depending on the type of engine.
Mounting
fans in each position of the motor axis.
Noise
fans emitted by the fan is tabulated, measurements are taken at a distance equal to three times the impeller diameter (but not less than 1.5 m) in the free acoustic field.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
