Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
The cabinet is made of impact-resistant plastic, the colour is white. The cabinet is designed for wall or ceiling mounting. There is a return flap in the fan discharge. The front panel contains a metal filter grille. A plastic check damper with a DN80 pipe connection is included.
Running wheel
The impeller is radial with forward curved blades. The impeller is statically and dynamically balanced.
Motor
The motor is a two-speed asynchronous motor with a start-up capacitor. The motor has thermal protection against overheating. The maximum operating ambient temperature is 40 ˚C. Double insulated design, IP44 protection.
Square box
The terminal block is accessible by removing the front grille and terminal cover, connecting flush or cable on plaster. The terminal block includes a relief clip to prevent the cable from being pulled out.
Speed control
Speed control for Type S using the REB stepless controller or REGUL 2 or COM 2 speed switch. For type T, a built-in timer switch automatically switches the speed so that when the LS terminal is disconnected, the fan runs at a lower speed for the set time. See wiring on next page.
Noise
Noise emitted by the fan is measured at a distance of 1.5 m in the axis of the fan on the intake side.
Variants
S - basic two-speed design
T - 2-30 min. run time, fan runs at lower speed
HT - 2-30 min. run time, hygrostat 60-90% RH, fan runs at lower speed
Mounting
Mounting is done on the wall using the paper mounting template included in the delivery. Dowels and screws are also included. When mounting, we recommend flexible pads under the fan mounting points to reduce noise transmission through the building structure.
Instructions
Two-speed fans are suitable for relatively long ducts with greater pressure drop or for direct through-wall ventilation. The fans can be used for ventilation in residential construction, in conjunction with a HIG 2 hygrostat or a hygrostat combined with a thermostat for ventilation of wet areas.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
