CADS Flexeo 210 BP static ventilation unit with heat recovery

Static ventilation units with heat recovery without fans or with separate fans.
Read more
B2B clients will see their prices after logging in
34 637,00 CZK excl. VAT
41 910,77 CZK incl. VAT
Availability: on request [20.8.2025, 04:10] Update
Goods cannot be ordered online.
Contact our sales specialists
or visit our branches.

Product code: SP300200110
EAN: 8413893720979
Manufacturer: S&P SISTEMAS DE VENTILACIÓN, S.L.U.   Read moreRead less

S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home

Product description
Cabinet

is black in colour and made of high quality EPP plastic. The necks are white and are rotatable by 90º. The inside of the unit is easily accessible thanks to special tension locks located on the cabinet. A condensate drain is led out from the bottom of the cabinet. The unit is equipped with an exchanger bypass in the BP version.

Fans

The unit is static - no fans.

Recuperation

The counterflow plate heat exchanger is plastic and has an efficiency of up to 94%. It is easily accessible from the top of the unit by undoing the tension locks. For summer operation, the BP version of the unit is equipped with an exchanger bypass.

Filter

The unit is equipped with 2 plate filters for exhaust air intake and fresh air intake, G4 (ISO coarse 65%) and M5 (ISO ePM10 50%). The filters are easily accessible from the top of the unit, no tools are required to remove them.

Outdoor filters

- AFR-FLEXEO Kit set of replacement filters G4 (ISO coarse 65%) and M5 (ISO ePM10 50%)

Regulation

Optionally, a remote control is available to enable BOOST mode (using additional components), control exchanger bypass and disable filter clogging messages.

Options

- CADS Flexeo standard version
- CADS Flexeo BP version with exchanger bypass

Mounting

The unit is designed for horizontal and vertical indoor installation. Its low height makes it ideal for installation in ceilings. Installation is carried out using clamps that attach directly to the unit. The unit must be mounted in such a way as to provide space for opening the unit lid, changing filters and connecting the condensate drain to the waste with a siphon cap.

Accessories

- ED Flex System® circular air ducts
- ED Plano System® square air ducts
- MBE-AFP 125/0.4 electric air preheater

Instructions

Due to the high efficiency of the heat exchanger, no preheating is usually necessary. In areas where temperatures are often below -5 °C, it is recommended to install a hot-water heat exchanger or an electric air preheater of adequate capacity (e.g. MBE-AFP 125/0.4) for fresh air intake. It is recommended to change filters at least once a year.

Information

Static ventilation unit with heat recovery (without fans). The unit is suitable in conjunction with external fans for apartment buildings or smaller commercial buildings. The unit is designed for permanent operation. Maximum flow rate 210 m3/h.

Full description
Safety regulations

Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:

• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.

Downloads
Technical sheets, manuals and declarations
Catalogblatt .pdf (2.65 MB)
Contact Us