Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Intelligent stand-alone wireless RH room humidity sensor enabling simultaneous temperature measurement (only via Modbus), RF version - wireless radio frequency communication between sensor and receiver AIRSENS-RF-REC. Each receiver can receive up to 4 signals simultaneously, allowing indoor air quality control in different rooms. Specially developed for controlling DCV systems and intelligent ventilation systems. They are suitable for use in offices, classrooms, shopping centers, restaurants, homes, fi t centers and other commercial buildings. IP30 protection.
- easy to install, wall mounted
- maintenance free during operation
- long life and stability
- operating point adjustment
- indication of IAQ (air quality) level by three coloured LED lights located on the bottom of the sensor
green - good
orange - degraded
red - poor
Operation is possible in 4 modes:
- switching output relay and Modbus (read)
- 0-10 V output and Modbus (read)
- 2-10 V output and Modbus (read)
- Modbus full control
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
