Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
is made of galvanized steel sheet, aluminium canopy, both coated with black epoxy lacquer.
Running wheel
is made of sheet steel.
Engine
is asynchronous with short armature, with triple windings for three speeds. The motors are equipped with a thermal fuse. Grease-filled ball bearings for life. Insulation class F. Protection class IP44.
Square box
is mounted on the fan housing, includes a start-up capacitor.
Mounting
The TH roof fans are mounted with a mounting base on horizontal roof structures or prefabricated masonry plinths. JMS and JBS plinths can also be used.
Speed control
is carried out as standard by a switch, if continuous regulation is required by changing the voltage by electronic or transformer regulators. When electronic phase-controlled regulators are used, intense parasitic noise can occur, especially at low speeds. In this case, a transformer control should be used.
Instructions
The fan is designed to exhaust air free of mechanical particles that could cause abrasion or imbalance of the impeller. Fans are particularly suitable for ventilation of sanitary facilities in apartment buildings.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
