Share on Facebook
Tweet
Send emailCabinet
is made of stainless steel sheet. A stainless steel square flange is attached to the cabinet for connection to the chimney flue. The fan is designed for outdoor installation.
Running wheel
is radial with forward curved blades, made of galvanized steel sheet. It is statically and dynamically balanced.
Motor
is asynchronous with short armature and is designed for continuous operation. The motor contains grease-filled ball bearings for life. The motor is not located in the flue stream. Protection rating IP34.
Screwdriver
is located on the fan housing as standard. Cable connection is possible by removing the terminal cover from the underside of the motor housing.
El. connection
cable to the fan terminal box. The fan is designed for fixed mounting. Supply voltage 230 V / 50 Hz.
Speed control
is carried out by electronic speed controllers by changing the voltage.
Mounting
The fan is mounted on the chimney casing with four screws, which are not included.
Instructions
The flue fan creates a vacuum in the chimney flue thanks to the included injector. The fan improves the draft of the chimney regardless of its effective height, wind speed or other environmental influences. The fan motor is located outside the flue gas stream. The fan is designed in such a way that its installation does not close the chimney flue. The maximum operating temperature of the fan is 400 °C.
Notice
The location of the fan and the construction of the chimney (or flue) must be carried out in accordance with the applicable technical standards and regulations. Emphasis must be placed on the fire safety of the chimney and flue, in particular their regular inspection and cleaning frequency. From the point of view of fire prevention, everyone is obliged to ensure that the operation of the chimney, flue and fuel appliance does not lead to fire. Furthermore, the Air Protection Act prohibits the use of waste as fuel. Inspections and checks of the entire system, including installation checks, must only be carried out by an authorised competent person.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
