Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
The cabinet is made of steel sheet, the finish is epoxy lacquer. There is a check valve in the discharge spout. The fan can be supplied with distribution chambers made of PLENUM zinc, which are noise-insulated and allow the connection of up to 7 Sonoflex® ducts or flexible ducts on the intake side of the fan. Unused intake outlets must be sealed with a DFL end cap.
Running wheel
The impeller is a radial impeller with forward curved blades, made of plastic (CKB 800 N) or galvanized steel sheet (CKB 1500 N). The impeller is dynamically and statically balanced.
Motor
The motor is asynchronous, with short armature, starting capacitor and thermal protection. Maximum operating temperature is 70 ˚C, insulation class F, protection class IP44.
Electrical connection
There is a 3-core cable leading from the fan, terminal block not included.
Speed control
Speed control is done by electronic or transformer regulators by changing the voltage.
Mounting
Mounted horizontally or vertically, preferably with the motor axis in the horizontal position, taking into account the bearing life. The fan can be supplied with a PLENUM inlet housing, which must be pressed onto the fan during mounting so that the fan housing is pressed into the foam seal in the groove of the inlet housing. PLENUM is attached to the CKB-N fan with self-tapping screws, and the gap between the fan and the enclosure is filled with a neutral silicone or acrylic sealant. CKB-N fans are mounted via ISA spring-loaded angles on the wall or via KSE vibration isolators on a fixed base.
Instructions
The ventilators are designed as central ventilation for houses, sanitary facilities, offices and smaller premises. Preferably, when installed in the soffit, flexhead and plate valves can be used. Fans can be used in conjunction with an SQA sensor for common room ventilation.
Adherence to these instructions should not pose any safety, health or environmental risks in accordance with EC directives (CE marked). The same applies to other products used in the device or during installation. Consider the following warnings:
• Observe the safety instructions to prevent damage to the device or personal injury.
• The technical information in this manual must not be changed.
• It is forbidden to interfere with the motor of the device.
• In order for the device to comply with EC directives, the device must be connected to the mains in accordance with the applicable regulations.
• The device must be installed in such a way that under normal operating conditions it cannot come into contact with any moving part and / or live part.
• The device complies with the applicable regulations for the operation of electrical equipment.
• Always disconnect the device from the power supply before carrying out any work on it.
• Appropriate tools must be used when handling or maintaining the device.
• The device must only be used for the purposes for which it is intended.
• This appliance is not intended for use by children under 8 years of age and persons with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a responsible person. The user must ensure that children do not play with the device. Cleaning and maintenance of the appliance must not be carried out by children without supervision.
