Share on Facebook
Tweet
Send email
S&P SISTEMAS DE VENTILACIÓN, S.L.U.
Llevant, 4
Polígono Industrial Llevant
08150 Parets del Vallès
Barcelona – Spain
consultas[zav]solerpalau[teč]com
www.solerpalau.com/en-en/home
Cabinet
The cabinet is made of high quality tough plastic (TD-350 to TD-1000) or epoxy coated galvanized steel sheet (TD-1300, TD-2000). Sizes TD-350 to TD-1000 include a patented vector noise absorber, sizes TD-1300 and TD-2000 have fiberglass noise insulation. The design allows for easy removal of the motor section.
Motor
EC motor with thermal and electronic overload protection. Ball bearings. Insulation class B, IP44 protection. Operating temperature -20 °C to +40 °C.
Clamps
The terminal block is located on the fan housing, it is rotatable 360° for cable connection from any direction (only for TD-350 to TD-1000). For sizes TD-1300 and TD-2000 the terminal block is removable, protection IP55.
Speed control
Motors are regulated by a potentiometer located in the terminal block or by an external REB-Ecowatt speed controller. The speed can also be controlled linearly by a 0-10 VDC signal from a temperature, humidity or CO2 sensor.
Mounting
Mounting is possible in any fan position. The enclosure must not transmit mechanical stresses from the ductwork. A flexible connection to the ductwork must be used.
Instructions
Due to their very low profile, high efficiency and low noise, the fans are suitable for demanding applications where their very economical operation is also applicable. They are also suitable for DCV (demand controlled ventilation) applications.
By following the instructions in the manual, no risk should arise regarding safety, health and the environment in accordance with the EC Directives (with CE marking). The same applies to other products used in the equipment or during installation. The following general information is important:
- observe the safety instructions to avoid damage to the equipment or personal injury
- the technical information given in these instructions must not be altered
- it is forbidden to interfere with the equipment's motor
- in order to comply with the EC directives, the equipment must be connected to the mains in accordance with the applicable regulations
- the equipment must be installed in such a way that, the equipment must comply with the applicable regulations for the operation of electrical equipment
- it must always be disconnected from the power supply before any tampering with the equipment
- appropriate tools must be used when handling or maintaining the equipment
- the equipment must be used only for the following purposes, for which it is intended
- this appliance must not be used by children under the age of 8 years and by persons with reduced physical, sensory or mental abilities, or persons with a lack of experience and knowledge, unless they are supervised by a responsible person or have been adequately instructed in the safe use of the appliance and can understand the risks involved
- the user must ensure that children do not play with the appliance
- cleaning and maintenance of the appliance must not be carried out by unsupervised children
