MDF30 EURO-M 1150x750 BF230T PITZN fire dampers for square pipe

Description

The MDF30 EURO-M square fire dampers serve as a closure for air ducts in case of fire. When the damper is closed, the spread of fire and the spread of smoke through the pipe from one fire compartment to another is prevented. Activation of the damper in the event of a fire is ensured by a 72 °C thermal fuse as standard. Closure of the damper after activation of the thermal fuse of the thermoelectric actuator is ensured by the closing spring of the actuator. The damper shell is made of two parts of galvanised steel sheet, separated by a calcium silicate plate to prevent heat transfer. It is fitted with two inspection holes. The flap sheet is made of calcium silicate plates. The blade rotates on steel pins mounted in bronze bushings. The flap is fitted with two limit switches. The flapper is designed to minimize pressure loss. The damper is fitted with a flange at both ends for connection to the air duct.

Features

CE marking according to EN 15650 certification, classification according to EN 13 501-3 is EI 90/120 S. Tested according to EN 1366-2 at 500 Pa.

Use

The flaps are suitable for installation in all common building structures such as rigid wall structures, lightweight partitions or rigid ceiling structures. The flap can be installed in fire separating construction with the axis of the sheet vertically or horizontally. Fire dampers can only be used for air free of mechanical and chemical impurities. Maximum flow velocity 10 m/s.

Mounting

The fire dampers are designed for square air ducts from 200x200 mm to 1500x800 mm (width x height). The axis of the damper must be inside the fire separation structure.

Notice

Fire dampers are dedicated fire safety devices (see the Ministry of Interior decree on fire prevention), therefore it is necessary to comply with the prescribed rules (training of installers, regular operational checks, etc.). Ask for information!

Accessories

- KS1 brackets for ceiling installation
- KS2 brackets for installation in lightweight partition
- RDH pipe inspection element